FAQ

Remo key-tuned Djembes are generally tensioned to perform right out of the box. Some professional players will match the open/bass tone to the root note of an ensemble. In most cases, it's player preference based on desired response and pitch. Note: the looser the head, the lower the tone/response...tighter the head, the higher the response/pitch. One suggestion would be on fine-tuning...with your finger, open-tap the head's edge near each rod and try to match the pitch all the way around by slightly turning each rod. Play with it till you get a nice balance of high slaps and bass tone from your drum.

Remo Symmetry Conga drumheads are designed specifically for non-Remo model Congas equipped with the latest version 'contoured/radial' hoops, i.e rims, as a standard among conga manufacturers-beginning since the late 90's. (If you have traditional hoops or would prefer tucked conga drumheads, please see other knowledge base post to confirm if drumheads are available for your model or contact our support center). Symmetry drumheads are specifically engineered to conform to the shells bearing edge with tension for optimum tone, pitch stability, and projection. Denotation: 'D' in the model number, denotes the inner diameter (ID) of the Aluminum Ring. D1 being the smallest, D4 being the largest-all specific to the type/model of the drum. Note the Crown size, i.e.playing surface remains the same: 9.75", 10.75" 11.06", 11.25”, 11.75", 12.25” 12.50", 13”.Due to non-standardized conga drum manufacturing, drumhead fit may vary...make sure to center and level as you tension for optimum performance. All listed models have been fit tested by Remo staff.

Remo Symmetry Conga drumheads are designed specifically for non-Remo model Congas equipped with the latest version 'contoured/radial' hoops, i.e rims, as a standard among conga manufacturers-beginning since the late 90's. (If you have traditional hoops or would prefer tucked conga drumheads, please see other knowledge base post to confirm if drumheads are available for your model or contact our support center). Symmetry drumheads are specifically engineered to conform to the shells bearing edge with tension for optimum tone, pitch stability, and projection. Denotation: 'D' in the model number, denotes the inner diameter (ID) of the Aluminum Ring. D1 being the smallest, D4 being the largest-all specific to the type/model of the drum. Note the Crown size, i.e.playing surface remains the same: 9.75", 10.75" 11.06", 11.25”, 11.75", 12.25” 12.50", 13”.Due to non-standardized conga drum manufacturing, drumhead fit may vary...make sure to center and level as you tension for optimum performance. All listed models have been fit tested by Remo staff. Gon Bop Congas: California Series, Alex Acuna Series Special Addition Series, Alex Acuna Signature Series, Tumbao Pro Series, Mariano Series. Drum sizes 10,11,11.25,12.25, 12.50"